'Dead Time' Limits Quantum Cryptography Speeds

Source:

http://www.sciencedaily.com/releases/2007/09/070928104257.htm

Science Daily — Quantum cryptography is potentially the most secure method of sending encrypted information, but does it have a speed limit" According to a new paper* by researchers at the National Institute of Standards and Technology (NIST) and the Joint Quantum Institute** (JQI), technological and security issues will stall maximum transmission rates at levels comparable to that of a single broadband connection, such as a cable modem, unless researchers reduce "dead times" in the detectors that receive quantum-encrypted messages.
In quantum cryptography, a sender, usually designated Alice, transmits single photons, or particles of light, encoding 0s and 1s to a recipient, "Bob." The photons Bob receives and correctly measures make up the secret "key" that is used to decode a subsequent message. Because of the quantum rules, an eavesdropper, "Eve," cannot listen in on the key transmission without being detected, but she could monitor a more traditional communication (such as a phone call) that must take place between Alice and Bob to complete their communication.
Modern telecommunications hardware easily allows Alice to transmit photons at rates much faster than any Internet connection. But at least 90 percent (and more commonly 99.9 percent) of the photons do not make it to Bob's detectors, so that he receives only a small fraction of the photons sent by Alice. Alice can send more photons to Bob by cranking up the speed of her transmitter, but then, they'll run into problems with the detector's "dead time," the period during which the detector needs to recover after it detects a photon. Commercially available single-photon detectors need about 50-100 nanoseconds to recover before they can detect another photon, much slower than the 1 nanosecond between photons in a 1-Ghz transmission.
Not only does dead time limit the transmission rate of a message, but it also raises security issues for systems that use different detectors for 0s and 1s. In that important "phone call," Bob must report the time of each detection event. If he reports two detections occurring within the dead time of his detectors, then Eve can deduce that they could not have come from the same detector and correspond to opposite bit values.
Sure, Bob can choose not to report the second, closely spaced photon, but this further decreases the key production rate. And for the most secure type of encryption, known as a one-time pad, the key has to have as many bits of information as the message itself.
The speed limit would go up, says NIST physicist Joshua Bienfang, if researchers reduce the dead time in single-photon detectors, something that several groups are trying to do. According to Bienfang, higher speeds also would be useful for wireless cryptography between a ground station and a satellite in low-Earth orbit. Since the two only would be close enough to communicate for a small part of the day, it would be beneficial to send as much information as possible during a short time window.
* D.J. Rogers, J.C. Bienfang, A. Nakassis, H. Xu and C.W. Clark, Detector dead-time effects and paralyzability in high-speed quantum key distribution, New Journal of Physics (September 2007);EJ/abstract/-kwd=nj-2f2/1367-2630/9/9/319.
**The JQI is a research partnership that includes NIST and the University of Maryland.
Note: This story has been adapted from material provided by National Institute of Standards and Technology.

Fausto Intilla
www.oloscience.com

Superconducting Quantum Computing Cable Created

Source:

http://www.sciencedaily.com/releases/2007/09/070926172232.htm

Science Daily — Physicists at the National Institute of Standards and Technology (NIST) have transferred information between two "artificial atoms" by way of electronic vibrations on a microfabricated aluminum cable, demonstrating a new component for potential ultra-powerful quantum computers of the future.

The setup resembles a miniature version of a cable-television transmission line, but with some powerful added features, including superconducting circuits with zero electrical resistance, and multi-tasking data bits that obey the unusual rules of quantum physics.
The resonant cable might someday be used in quantum computers, which would rely on quantum behavior to carry out certain functions, such as code-breaking and database searches, exponentially faster than today's most powerful computers.
Moreover, the superconducting components in the NIST demonstration offer the possibility of being easier to manufacture and scale up to a practical size than many competing candidates, such as individual atoms, for storing and transporting data in quantum computers.
Unlike traditional electronic devices, which store information in the form of digital bits that each possess a value of either 0 or 1, each superconducting circuit acts as a quantum bit, or qubit, which can hold values of 0 and 1 at the same time. Qubits in this "superposition" of both values may allow many more calculations to be performed simultaneously than is possible with traditional digital bits, offering the possibility of faster and more powerful computing devices. The resonant section of cable shuttling the information between the two superconducting circuits is known to engineers as a "quantum bus," and it could transport data between two or more qubits.
The NIST work is featured on the cover of the Sept. 27 issue of Nature. The scientists encoded information in one qubit, transferred this information as microwave energy to the resonant section of cable for a short storage time of 10 nanoseconds, and then successfully shuttled the information to a second qubit.
"We tested a new element for quantum information systems," says NIST physicist Ray Simmonds. "It's really significant because it means we can couple more qubits together and transfer information between them easily using one simple element."
The NIST work, together with another letter in the same issue of Nature by a Yale University group, is the first demonstration of a superconducting quantum bus. Whereas the NIST scientists used the bus to store and transfer information between independent qubits, the Yale group used it to enable an interaction of two qubits, creating a combined superposition state. These three actions, demonstrated collectively by the two groups, are essential for performing the basic functions needed in a superconductor-based quantum information processor of the future.
In addition to storing and transferring information, NIST's resonant cable also offers a means of "refreshing" superconducting qubits, which normally can maintain the same delicate quantum state for only half a microsecond. Disturbances such as electric or magnetic noise in the circuit can rapidly destroy a qubit's superposition state. With design improvements, the NIST technology might be used to repeatedly refresh the data and extend qubit lifetime more than 100-fold, sufficient to create a viable short-term quantum computer memory, Simmonds says. NIST's resonant cable might also be used to transfer quantum information between matter and light -- microwave energy is a low-frequency form of light -- and thus link quantum computers to ultra-secure quantum communications systems.
If they can be built, quantum computers -- harnessing the unusual rules of quantum mechanics, the principles governing nature's smallest particles -- might be used for applications such as fast and efficient code breaking, optimizing complex systems such as airline schedules, making counterfeit-proof money, and solving complex mathematical problems. Quantum information technology in general allows for custom-designed systems for fundamental tests of quantum physics and as-yet-unknown futuristic applications.
A superconducting qubit is about the width of a human hair. NIST researchers fabricate two qubits on a sapphire microchip, which sits in a shielded box about 8 cubic millimeters in size. The resonant section of cable is 7 millimeters long, similar to the coaxial wiring used in cable television but much thinner and flatter, zig-zagging around the 1.1 mm space between the two qubits. Like a guitar string, the resonant cable can be stimulated so that it hums or "resonates" at a particular tone or frequency in the microwave range. Quantum information is stored as energy in the form of microwave particles or photons.
The NIST research was supported in part by the Disruptive Technology Office.
*M.A. Sillanpää, J.I. Park, and R.W. Simmonds. 2007. Coherent quantum state storage and transfer between two phase qubits via a resonant cavity. Nature, Sept. 27.
Note: This story has been adapted from a news release issued by National Institute of Standards and Technology.

Fausto Intilla

www.oloscience.com

Two Giant Steps In Advancement Of Quantum Computing Achieved

Source:

http://www.sciencedaily.com/releases/2007/09/070926172350.htm

Science Daily — Two major steps toward putting quantum computers into real practice -- sending a photon signal on demand from a qubit onto wires and transmitting the signal to a second, distant qubit -- have been brought about by a team of scientists at Yale.

The accomplishments are reported in sequential issues of Nature on September 20 and September 27, on which it is highlighted as the cover along with complementary work from a group at the National Institute of Standards and Technologies.
Over the past several years, the research team of Professors Robert Schoelkopf in applied physics and Steven Girvin in physics has explored the use of solid-state devices resembling microchips as the basic building blocks in the design of a quantum computer. Now, for the first time, they report that superconducting qubits, or artificial atoms, have been able to communicate information not only to their nearest neighbor, but also to a distant qubit on the chip.
This research now moves quantum computing from "having information" to "communicating information." In the past information had only been transferred directly from qubit to qubit in a superconducting system. Schoelkopf and Girvin's team has engineered a superconducting communication 'bus' to store and transfer information between distant quantum bits, or qubits, on a chip. This work, according to Schoelkopf, is the first step to making the fundamentals of quantum computing useful.
The first breakthrough reported is the ability to produce on demand -- and control -- single, discrete microwave photons as the carriers of encoded quantum information. While microwave energy is used in cell phones and ovens, their sources do not produce just one photon. This new system creates a certainty of producing individual photons.
"It is not very difficult to generate signals with one photon on average, but, it is quite difficult to generate exactly one photon each time. To encode quantum information on photons, you want there to be exactly one," according to postdoctoral associates Andrew Houck and David Schuster who are lead co-authors on the first paper.
"We are reporting the first such source for producing discrete microwave photons, and the first source to generate and guide photons entirely within an electrical circuit," said Schoelkopf.
In order to successfully perform these experiments, the researchers had to control electrical signals corresponding to one single photon. In comparison, a cell phone emits about 10^23 (100,000,000,000,000,000,000,000) photons per second. Further, the extremely low energy of microwave photons mandates the use of highly sensitive detectors and experiment temperatures just above absolute zero.
"In this work we demonstrate only the first half of quantum communication on a chip -- quantum information efficiently transferred from a stationary quantum bit to a photon or 'flying qubit,'" says Schoelkopf. "However, for on-chip quantum communication to become a reality, we need to be able to transfer information from the photon back to a qubit."
This is exactly what the researchers go on to report in the second breakthrough. Postdoctoral associate Johannes Majer and graduate student Jerry Chow, lead co-authors of the second paper, added a second qubit and used the photon to transfer a quantum state from one qubit to another. This was possible because the microwave photon could be guided on wires -- similarly to the way fiber optics can guide visible light -- and carried directly to the target qubit. "A novel feature of this experiment is that the photon used is only virtual," said Majer and Chow, "winking into existence for only the briefest instant before disappearing."
To allow the crucial communication between the many elements of a conventional computer, engineers wire them all together to form a data "bus," which is a key element of any computing scheme. Together the new Yale research constitutes the first demonstration of a "quantum bus" for a solid-state electronic system. This approach can in principle be extended to multiple qubits, and to connecting the parts of a future, more complex quantum computer.
However, Schoelkopf likened the current stage of development of quantum computing to conventional computing in the 1950's, when individual transistors were first being built. Standard computer microprocessors are now made up of a billion transistors, but first it took decades for physicists and engineers to develop integrated circuits with transistors that could be mass produced.
Schoelkopf and Girvin are members of the newly formed Yale Institute for Nanoscience and Quantum Engineering (YINQE), a broad interdisciplinary activity among faculty and students from across the university.
Other Yale authors involved in the research are J.M. Gambetta, J.A. Schreier, J. Koch, B.R. Johnson, L. Frunzio, A. Wallraff, A. Blais and Michel Devoret. Funding for the research was from the National Security Agency under the Army Research Office, the National Science Foundation and Yale University.
Citation: Nature 449, 328-331 (20 September 2007) doi:10.1038/nature06126 , Nature 450, 443-447 (27 September 2007) doi:10.1038/nature06184
Note: This story has been adapted from a news release issued by Yale University.

Fausto Intilla

www.oloscience.com